Camry CE Sedan 4-Door L4-2164cc 2.2L DOHC MFI (1997)
4. Temporarily install no.1 idler pulley and tension spring
a. Align the bracket pin hole with the pivot pin.
b. Install the pulley with the bolt. Do not tighten the bolt yet.
NOTE: Use the 42 mm (1.65 in.) long bolt.
c. Install the tension spring.
d. Pry the pulley toward the left as far as it will go, and tighten the bolt.
e. Check that the idler pulley moves smoothly.
5. Temporarily install timing belt
Notice: The engine should be cold.
a. Using the crankshaft pulley bolt, turn the crankshaft and align the timing marks of the crankshaft timing pulley and oil pump body.
b. Remove any oil or water on the crankshaft pulley, oil pump pulley, water pump pulley, No.1 idler pulley and No.2 idler pulley, and keep them
clean.
c. Install the timing belt on the crankshaft timing pulley, oil pump pulley, No.1 idler pulley, water pump pulley and No.2 idler pulley.
NOTE: When re-using timing belt, align the points marked during removal, and install the belt with the arrow pointing in the direction of
engine revolution.