Camry CE Sedan 4-Door L4-2164cc 2.2L DOHC MFI (1997)
c. Check that each pulley aligns with the timing marks as shown in the illustration.
If the timing marks do not align, remove the timing belt and reinstall it.
d. Slowly turn the crankshaft pulley 1 and 7/8 revolutions, and align its groove with the mark at 45° BTDC (for No.1 cylinder) of the No.1 timing
belt cover.
NOTE: Always turn the crankshaft pulley clockwise.
e. Tighten the mounting bolt of the No.1 idler pulley.
Torque: 42 Nm (31 ft lbs.)
13. Install no.2 timing belt cover
a. Check that the timing belt cover gaskets have no cracks or peeling, etc.
If the gasket has cracks or peeling, etc., replace it using these steps:
^
Using a screwdriver and gasket scraper, remove all the old gasket material.
^
Thoroughly clean all components to remove all the loose material.
^
Remove the backing paper from a new gasket and install the gasket evenly to the part of the timing belt cover shaded black in the
illustration.
^
After installing the gasket, press down on it so that the adhesive firmly sticks to the timing belt cover.
