Camry CE Sedan 4-Door L4-2164cc 2.2L DOHC MFI (1997)
Injector Installation - Except California
4. Install the injector to the delivery pipe and intake manifold, as shown in the illustration.
Before installing the injector, must apply spindle oil or gasoline on the place where a delivery pipe or an intake manifold touches an O-ring of the
injector.
5. Observe these precautions when disconnecting and connecting the fuel tube connector (quick type). Precaution for Disconnecting Operation:
(a) Check if there is any dirt like mud on the pipe and around the connector before disconnecting them and clean the dirt away.
(b) Be sure to disconnect with hands.
(c) When the connector and the pipe are stuck, pinch the retainer between the hands, push and pull the connector to free to disconnect and pull it
out. Do not use any tool at this time.
(d) Inspect if there is any dirt or the likes on the seal surface of the disconnected pipe and clean it away.
(e) Prevent the disconnected pipe and connector from damaging and mixing foreign objects by covering them with a vinyl bag.
Precaution for Connecting Operation:
(a) Do not reuse the retainer removed from the pipe.
(b) Must use hands without using tools when to remove the retainer from the pipe.
(c) Check if there is any damage or foreign objects on the connected part of the pipe.
(d) Match the axis of the connector with axis of the pipe, and push in the connector until the retainer makes a "click" sound. In case that the
connections is tight, apply little amount of new engine oil on the tip of the pipe.
(e) After having finished the connection, check if the pipe at the connector are securely connected by pulling them.
(f) Check if there is any fuel leakage.
