Camry CE Sedan 4-Door L4-2164cc 2.2L DOHC MFI (1997)
NOTE:
-
Use a torque wrench with a fulcrum length of 300 mm (11.81 inch).
-
Disconnect the clamp with engine wire.
c. Torque the B bolt to 43 Nm (32 ft. lbs.).
e. Connect the connector to the oil pressure switch.
4. Connect pressure feed tube.
a. Using SST 09631 - 22020, connect the tube, torque to 20 Nm (15 ft. lbs.).
NOTE:
-
Use a torque wrench with a fulcrum length of 300 mm (11.81 inch).
-
This torque value is effective in case that SST is parallel to a torque wrench.
b. Install the 2 clamp plates and 2 holders to the tube.
c. Tighten the bolt.
d. Install the 2 clamp plate set nuts, torque to 7.8 Nm (69 inch lbs.).
5. Connect return hose.
6. Install front fender apron seal RH. Tighten the 2 bolts.
7. Bleed power steering system. See: Power Steering Bleeding/Service and Repair