Camry CE Sedan 4-Door L4-2164cc 2.2L DOHC MFI (1997)
Torque Converter Clutch: Testing and Inspection
1. Inspect one-way clutch.
a. Install Special Service Tool (SST) into the inner race of the one-way clutch.
SST 0 935-32014 (09351-32020)
b. Install SST so that it fits in the notch of the converter hub and outer race of the one-way clutch.
SST 0 935-32014 (09351-32020)
c. With the torque converter clutch standing on its side, the clutch locks when turned counterclockwise, and rotates freely and smoothly
clockwise.
If necessary, clean the converter and retest the clutch. Replace the converter clutch if the clutch still fails the test.
2. Measure torque converter clutch sleeve runout.
a. Temporarily mount the torque converter clutch to the drive plate.
Set up a dial indicator and measure the torque converter clutch sleeve runout.
Maximum runout: 0.30 mm (0.0118 inch).
If the runout is not within the specification, try to correct by reorienting the installation of the torque converter clutch. If excessive runout
cannot be corrected, replace the torque converter clutch.
HINT: Mark the position of the torque converter clutch to ensure the correct installation.
b. Remove the torque converter clutch.
