Camry Coupe 2-Door L4-132 2164cc 2.2L DOHC (5S-FE) (1995)
Fuel Gauge: Testing and Inspection
1. Disconnect connector from sender gauge.
2. Turn ignition switch to On position, then check receiver gauge needle indicates Empty.
3. Connect terminals 2 and 3 on wire harness side connector through a 3.4W test bulb, Fig. 35.
Fig. 35 Fuel Receiver Gauge Inspection.
4. Turn ignition switch On, then ensure bulb lights and receiver gauge needle moves toward full side.
Fig. 36 Fuel Gauge Terminal Locations.
5. Measure resistance between terminals A, B and C, Fig. 36. Resistance should be as follows:
a. A-B: about 126.0 ohms.
b. A-C: about 281.0 ohms.
c. B-C: about 154.0 ohms.
d. If resistance is not as specified, replace receiver gauge.
6. Connect a series of three 1.5 volt dry cell batteries.
7. Connect the positive lead from the dry cell batteries to terminal 2 through a 3.4W test bulb and the negative lead to terminal 3, Fig. 38.