Camry Coupe 2-Door V6-3.0L (1MZ-FE) (1996)
Fuel Pressure Release: Service and Repair
FUEL PRESSURE RELEASE PROCEDURE
CAUTION:
^
DO NOT smoke during this procedure.
^
Use of protective eye wear is recommended when opening a pressurized fuel fitting.
When disconnecting the fuel high pressure line, a large amount of gasoline will spill out, so observe the following procedures:
-
Disconnect the fuel pump connector.
-
Start the engine.
-
After the engine has stopped on its own, turn the ignition switch to LOCK.
-
Put a container under the connection.
-
Slowly loosen the connection.
-
Toyota recommends using a fuel filter connection for this process.
-
Disconnect the connection.
-
Plug the connection with a rubber plug.
When connecting the flare nut or union bolt on the high pressure pipe union, observe the following procedures:
Union Bolt Type:
-
Always use 2 new gaskets.
-
Tighten the union bolt by hand.
-
Tighten the union bolt to the specified torque.
Torque: 30 Nm (310 kgf.cm; 21 ft.lb)
Flare Nut Type: