Camry Coupe 2-Door V6-3.0L (1MZ-FE) (1996)
-
Using SST, remove the knock sensor.
SST 09817-16011
7. INSPECT KNOCK SENSORS
-
Using an ohmmeter, check that there is no continuity between the terminal and body.
-
If there is continuity, replace the sensor.
8. REINSTALL KNOCK SENSORS
-
Using SST, install the knock sensor.
SST 09817-16011
Torque: 39 Nm (400 kgf.cm, 29 ft.lb)
-
Connect the knock sensor connector.
9. REINSTALL WATER OUTLET AND RH ENGINE MOUNTING STAY
-
Install 2 new gaskets on the cylinder head.
-
Install the water outlet with the 2 bolts, 2 plate washers and 2 nuts.
Torque: 15 Nm (150 kgf.cm, 11 ft.lb)
NOTICE: Do not scratch the seal surface of the water outlet with the stud bolt.
-
Connect the water bypass hose to the inlet housing.
-
Install the wire band.