Camry Coupe 2-Door V6-3.0L (1MZ-FE) (1996)
/Page-1271005.png)
1. Install No.2 dust deflector; using Special Service Tool (SST) 09309 - 36010, 09316 - 20011 and a press.
2. Assemble inboard joint shaft (RH Drive Shaft).
a. Install a new snap ring to the inboard joint shaft.
b. Using SST 09223 - 56010 and a press, install a new bearing.
c. Using a snap ring expander, install a new snap ring.
d. Using SST 09223 - 56010 and a press, install a new dust cover.
3. Install dust cover.
LH Drive Shaft - Using SST 09223 - 56010, 09555 - 55010 and a press, install a dust cover.
RH Drive Shaft - Using SST 09223 - 56010 and a press, install a new dust cover until the distance from the tip of the inboard joint shaft to the
dust cover falls within the specification, as shown in the illustration.
