Camry LE Sedan L4-2164cc 2.2L DOHC (5S-FE) MFI (2000)
_mfi/Page-1458001.png)
Power Door Lock Actuator: Testing and Inspection
INSPECT MOTOR OPERATION
a. Connect the positive (+) lead from the battery to terminal 3 and the negative (-) lead to terminal 2, and check that the door lock link moves to
UNLOCK position.
b. Remove the polarity and check that the door lock link moves to LOCK position.
If operation is not as specified, replace the door lock assembly.
Using an ammeter:
INSPECT PTC THERMISTOR OPERATION
a. Connect the positive (+) lead from the battery to terminal 3.
b. Connect the positive (+) lead from the ammeter to terminal 2 and the negative (-) lead to battery negative (-) terminal, and check that the current
changes from approximately 3.2 A to less than 0.5 A within 20 to 70 seconds.
c. Disconnect the leads from terminals.
d. Approximately 60 seconds later, connect the positive (+) lead from the battery to terminal 2 and the negative (-) lead to terminal 3, and check that
the door lock moves to the LOCK position.
If operation is not as specified, replace the door lock assembly.
Using an ammeter with a current-measuring probe:
INSPECT PTC THERMISTOR OPERATION
