Camry LE Sedan L4-2164cc 2.2L DOHC (5S-FE) MFI (2000)
HINT: When inspecting "REAR LH" position, push the REAR LH switch instead of the POWER SWITCH, and you can inspect in any
selector switch position.
o. Push and hold in the MOTOR switch for a few seconds.
p. Stop the engine.
5. DISCONNECT ACTUATOR CHECKER (SST) FROM ACTUATOR
Remove the "SHEET A" (SST) and disconnect the actuator checker (SST) and sub wire harness (SST) from the actuator.
SST 09990-00150, 09990-00163, 09990-00250, 09990-00360, 09990-00450
6. CONNECT CONNECTORS
Connect the 2 connectors to the actuator.
7. CLEAR DTC
ABS (TMC/Denso Made)
ON-VEHICLE INSPECTION
HINT: Using the ABS actuator checker (SST), check the operation of the actuator. If the actuator does not operate, check the operation of sub-wire
harness G. If the solenoid and/or pump motor relay are abnormal, replace the relay and inspect the actuator operation again.
1. INSPECT BATTERY POSITIVE VOLTAGE
Battery positive voltage: 10 - 14 V
2. DISCONNECT CONNECTORS
Disconnect the 2 connectors from the actuator.
3. CONNECT ACTUATOR CHECKER (SST)
a. Connect the actuator checker (SST) to the actuator side wire harness via the sub-wire harness (SST), as shown.
SST 09990-00150, 09990-00250, 09990-00300, 09990-00360