Camry LE Sedan L4-2164cc 2.2L DOHC (5S-FE) MFI (2000)
_mfi/Page-995001.png)
Hydraulic Control Assembly - Antilock Brakes: Testing and Inspection
On-Vehicle Inspection
ABS & TRAC Actuator
ON-VEHICLE INSPECTION
HINT: Using the ABS actuator checker (SST), check the operation of the actuator. If the actuator does not operate, check the operation of sub-wire
harness G according to the instructions on pages DI-545 and DI-548. If the solenoid and/or pump motor relay are abnormal, replace the relay and
inspect the actuator operation again.
1. INSPECT BATTERY POSITIVE VOLTAGE
Battery positive voltage: 10 - 14 V
2. DISCONNECT CONNECTORS
Disconnect the 2 connectors from the actuator.
3. CONNECT ABS ACTUATOR CHECKER (SST)
a. Connect the actuator checker (SST) to the actuator side wire harness via the sub-wire harness (SST), as shown.
SST 09990-00150, 09990-00250, 09990-00360, 09990-00450
b. Connect the red cable of the checker to the battery positive (+) terminal and black cable to the negative (-) terminal. Connect the black cable of
the sub-wire harness to the battery negative (-) terminal or body ground.
c. Place the "SHEET A" (SST) on the actuator checker.
