Camry LE Sedan L4-2164cc 2.2L DOHC (5S-FE) MFI (2000)
_mfi/Page-576001.png)
Ignition Cable: Testing and Inspection
INSPECT HIGH-TENSION CORDS
a. Remove the high-tension cords.
-
Disconnect the high-tension cords at the rubber boot. Do not pull on the high-tension cords.
NOTE: Pulling on or bending the cords may damage the conductor inside.
b. Using an ohmmeter, measure the high-tension cord resistance. Maximum resistance: 25 kOhms per cord
-
If the resistance is greater than maximum, check the terminals.
-
If necessary, replace the high-tension cord.
c. Reinstall the high-tension cords.
