Camry LE Sedan L4-2164cc 2.2L DOHC (5S-FE) MFI (2000)
Alignment: Service and Repair
Front Wheel Alignment
NOTICE: For Zero Point Calibration information, please refer to: TSB T-SB-0020-8 (3/25/08).
INSPECTION
1. MEASURE VEHICLE HEIGHT
*1: Front measuring point
Measure from the ground to the center of the front side lower suspension arm mounting bolt.
*2: Rear measuring point
Measure from the ground to the center of the strut rod mounting bolt.
NOTICE: Before inspecting the wheel alignment, adjust the vehicle height to the specification.
If the vehicle height is not within the specification, try to adjust it by pushing down on or lifting the body.
2. INSTALL CAMBER-CASTER-KINGPIN GAUGE ONTO VEHICLE OR POSITION VEHICLE ON WHEEL ALIGNMENT TESTER
Follow the specific instructions of the equipment manufacturer.