Camry LE Sedan L4-2164cc 2.2L DOHC (5S-FE) MFI (2000)
_mfi/Page-1195003.png)
b. Remove the bolt and nut, and disconnect the strut rod from the rear axle carrier.
NOTICE: When removing/installing bolt, stop the nut from rotating and loosen/torque the bolt.
Torque: 113 Nm (1,150 kgf.cm, 83 ft. lbs.)
c. Remove the 2 nuts and bolts on the lower side of the shock absorber.
d. Remove the nut, bolt and No.2 lower suspension arm.
e. Remove the rear axle carrier.
INSTALLATION
Installation is in the reverse order of removal.
AFTER INSTALLATION, CHECK ABS SPEED SENSOR SIGNAL AND REAR WHEEL ALIGNMENT
For information on the testing procedures of the ABS speed sensor signal, refer to Brakes and Traction Control; Brakes; Antilock Brake System;
Wheel Speed Sensor; Testing and Inspection; Procedures.
