Camry LE Sedan L4-2164cc 2.2L DOHC (5S-FE) MFI (2000)
c. Check to see that there is no remarkable play in the radial direction of the inboard joint shaft.
d. Check for damage to boots.
2. REMOVE INBOARD AND OUTBOARD JOINT BOOT CLAMPS
a. Using pliers, draw the hooks together and remove the large inboard joint boot clamp.
b. Using a side cutter, cut the small inboard and 2 outboard joint boot clamps and remove them.
3. REMOVE INBOARD JOINT SHAFT
a. Place matchmarks on the tripod, inboard and outboard joint shafts.
NOTICE: Do not punch the marks.
b. Remove the inboard joint shaft from the outboard joint shaft.
4. REMOVE TRIPOD
a. Using a snap ring expander, remove the snap ring.
b. Using a snap ring expander, temporarily slide the snap ring toward the outboard joint shaft side.
c. Place matchmarks on the outboard joint shaft and tripod.
d. Using a brass bar and hammer, remove the tripod from the outboard joint shaft.
e. Using a snap ring expander, remove the snap ring.
5. REMOVE INBOARD AND OUTBOARD JOINT BOOTS
Slide out the 2 boots.
NOTICE: Do not disassemble the outboard joint.
6. REMOVE DUST COVER
-
(LH drive shaft)
Using SST and a press, remove the dust cover from the inboard joint shaft.
SST 09950-00020