Camry LE Sedan V6-3.0L (1MZ-FE) (1998)
/Page-1590001.png)
Hydraulic Control Assembly - Antilock Brakes: Testing and Inspection
ABS (TMMK/Bosch Made)
ON-VEHICLE INSPECTION
HINT: Using the ABS actuator checker Special Service Tool (SST) 09990-00150, 09990-00250, 09990-00360, 0O99-00450 or equivalent, check the
operation of the actuator. If the actuator does not operate, check the operation of sub-wire harness G. If the solenoid and/or pump motor relay are
abnormal, replace the relay and inspect the actuator operation again.
1. Inspect battery positive voltage.
Battery positive voltage: 10 - 14 V
2. Disconnect connectors.
Disconnect the 2 connectors from the actuator.
3. Connect actuator checker. (SST)
a. Connect the actuator checker (SST) to the actuator side wire harness via the sub-wire harness (SST), as shown.
b. Connect the red cable of the checker to the battery positive (+) terminal and black cable to the negative (-) terminal. Connect the black cable of
the sub-wire harness to the battery negative (-) terminal or battery.
c. Place the "SHEET A" SST 09990-00163 on the actuator checker.
4. Inspect brake actuator operation.
a. Start the engine, and run it at idle.
