Camry LE Sedan V6-3.0L (1MZ-FE) (1998)
Fluid - A/T: Testing and Inspection
1. CHECK FLUID LEVEL
HINT:
-
Only use the COOL range on the dipstick as a rough reference when the fluid is replaced or the engine does not run.
-
Drive the vehicle so that the engine and transaxle are at normal operating temperature.
Fluid temp: 70 - 80° (158 - 176°F)
-
Park the vehicle on a level surface and set the parking brake.
-
With the engine idling and the brake pedal depressed, shift the shift lever into all positions from P to L position and return to P position.
-
Pull out the oil level gauge and wipe it clean.
-
Push it back fully into the pipe.
-
Pull it out and check that the fluid level is in the HOT range.
-
If the level is at the low side, add fluid.
NOTICE: Do not overfill.
Fluid type: ATF DEXRON II
2. CHECK FLUID CONDITION
-
If the fluid smells burnt or is black, replace it.
3. REPLACE TRANSAXLE FLUID
-
Using a 10 mm hexagon wrench, remove the drain plug and drain the fluid.
-
Reinstall the drain plug securely.