Camry LE Sedan V6-3.0L (1MZ-FE) (1998)
a. Install the connector clamp and pipe retainer.
b. Install and torque the 2 bolts.
Bolt length:
Bolt A: 48 mm (1.890 inch)
Bolt B: 39 mm (1.535 inch)
Torque: 11 Nm (110 kgf-cm, 8 ft. lbs.)
19. INSTALL MANUAL VALVE BODY
a. Align the manual valve with the pin on the manual shaft lever.
b. Lower the manual valve body into place.
c. Hand tighten the 5 bolts first. Then, tighten them with a torque wrench.
Bolt length:
Bolt A: 22 mm (0.866 inch)
Bolt B: 37 mm (1.457 inch)
Torque: 11 Nm (110 kgf-cm, 8 ft. lbs.)
20. INSTALL DETENT SPRING AND OIL PIPE
a. Place the detent springs on the manual valve body and hand tighten the 2 bolts first. Then, tighten them with a torque wrench.
Bolt length:
Bolt A: 14 mm (0.551 inch)
Bolt B: 37 mm (1.457 inch)
Torque: 11 Nm (110 kgf-cm, 8 ft. lbs.)
b. Check that the manual valve lever is touching the center of the detent spring tip roller.
c. Using a plastic hammer, install the pipe into the position.
NOTICE: Be careful not to bend or damage the pipe.
d. Install and torque the bolt.
Torque: 10 Nm (100 kgf-cm, 7 ft. lbs.)