Camry LE Sedan V6-3.0L (1MZ-FE) (1998)
SST 09950 - 40010
2. Remove ring gear.
-
Place matchmarks on both the differential case and ring gear.
b. Remove the 16 bolts.
c. Using a plastic hammer, tap the ring gear and remove it.
3. Disassemble differential case.
a. Place matchmarks on the differential right and left cases.
b. Using a torx wrench (T50), remove the 16 torx screws.
c. Using a plastic hammer, tap the differential left case.
d. Remove the vehicle speed sensor drive gear from the differential right case.
e. Remove the 2 differential side gears, side gear thrust washers, 4 differential pinions and pinion thrust washers from the differential left case.
4. Transmission Case Side:
-
If necessary, replace oil seal and tapered roller bearing outer race.
a. Using a screwdriver, remove the oil seal.
b. Remove the oil baffle.
c. Using a brass bar and hammer, drive out the bearing outer race lightly and evenly.
d. Remove the shim.
e. Install the shim.
HINT: First select and install a shim of lesser thickness than before.