Camry LE Sedan 4-Door L4-2164cc 2.2L DOHC MFI (1997)
Spoiler: Technical Service Bulletins
Body - Rear Spoiler Installation
ACCESSORY
AX005-97
April 25, 1997
Title:
1997 CAMRY REAR SPOILER INSTALLATION
Models:
'97 Camry
Introduction
Upon installation of the rear spoiler, as outlined in the Dealer Installation Instruction sheet enclosed with the spoiler, please follow the outlined
procedure for verification of the trunk lid operation:
Affected Vehicles
1997 Model Year Camry.
Procedure
1.
Reinstall the carpet trim panel on the inside of the trunk lid with the appropriate fasteners.
2.
The trunk lid must remain open and hold its position, up to approximately 45 degrees from horizontal as shown.
3.
If the trunk lid does not hold its open position and the trunk lid closes:
a.
Move the end of one of the torsion rods to the next upper open slot.
b.
Verify that the trunk lid functions as outlined above.
c.
If the condition is not corrected, adjust the other torsion bar to the next upper open slot position.
4.
If the trunk lid does not hold its open position and the trunk lid opens fully forcibly:
a.
Move the end of one of the torsion rods to the next lower open slot position.
