Camry LE Sedan 4-Door L4-2164cc 2.2L DOHC MFI (1997)
INSPECTION
NOTE: Using the ABS Actuator checker (SST), check the operation of the actuator. If the Actuator does not operate, check the operation of sub-wire
harness G. If the solenoid and/or Pump Motor Relay are abnormal, replace the relay and inspect the Actuator operation again.
1. Inspect battery positive voltage.
Battery positive voltage: 10-14V
ABS Actuator Connectors
2. Disconnect connectors.
Disconnect the 2 connectors from the Actuator.
ABS Actuator Sub-Harnesses G & L
3. Connect Actuator checker (SST).
(a) Connect the Actuator checker (SST) to the Actuator side wire harness via the sub-wire harness (SST), as shown.
SST 09990-00150, 09990-00250, 09990-00300, 09990-00360
(b) Connect the red cable of the checker to the battery positive (+) terminal and black cable to the negative (-) terminal. Connect the black
cable of the sub-wire harness to the battery negative (-) terminal or body ground.
(c) Place the "SHEET P" (SST) on the Actuator checker.
SST O9990-OO43O
4. Inspect brake Actuator operation.
(a) Start the engine, and run it at idle.
