Camry LE Sedan 4-Door L4-2164cc 2.2L DOHC MFI (1997)
Brake Bleeding: Service and Repair
Bleeding the Brake System
BRAKE FLUID BLEEDING
CAUTION: Do not let brake fluid remain on a painted surface. Wash it off immediately.
NOTE: If any work is done on the brake system or if air is suspected in the brake lines, bleed the system of air.
1. Fill brake reservoir with brake fluid.
Fluid: SAEJ17O3 or FMVSS No.116 DOT 3
Check the fluid level in the reservoir after bleeding each wheel. Add fluid, if necessary.
2. Bleed Master Cylinder.
NOTE: If the Master Cylinder has been disassembled or if the reservoir becomes empty, bleed the air from the Master Cylinder.
(a) Disconnect the brake lines from the Master Cylinder.
(b) Slowly depress the brake pedal and hold it.
(c) Block off the outlet plugs with your fingers, and release the brake pedal.
(d) Repeat (b) and (c) 3 or 4 times.
3. Connect vinyl tube to Brake Caliper bleeder plug or Wheel Cylinder bleeder plug.
Insert other end of the tube in a half-full container of brake fluid.
