Camry LE Sedan 4-Door L4-2164cc 2.2L DOHC MFI (1997)
(a)
Remove the drain plug.
(b) Remove the O-ring.
3. Assemble Special Service Tool (SST) Radiator Service Tool Set # 09230 - 01010 or equivalent.
(a)
Install the claw to the overhaul handle, inserting it in the hole in part "A" as shown in the diagram.
(b) While gripping the handle, adjust the stopper bolt so that dimension "B" shown in the diagram is 0.2 - 0.3 mm (0.008 - 0.012 inch).
CAUTION: If this adjustment is not done the claw may be damaged.
4. Uncaulk lock plates.
Using SST Radiator Service Tool Set # 09230 - 01010 or equivalent to release the caulking, squeeze the handle until stopped by the stopper bolt.
5. Remove tanks and O-rings.
Lightly tap the bracket of the radiator (or radiator inlet or outlet) with a soft-faced hammer, and remove the tank and the O-ring.
6. A/T: Remove oil cooler from lower tank.
(a)
Loosen the nut, and remove the bolt and cooler pipe.
(b) Remove the 2 nuts and plate washers.
(c)
Remove the oil cooler and 2 O-rings.
Assembly
