Camry LE Sedan 4-Door L4-2164cc 2.2L DOHC MFI (1997)
f.
Using pliers, compress the snap ring.
g. Check that the snap ring fits correctly.
h. Remove the starter housing and clutch assembly from the brass bar.
i.
Using a plastic-faced hammer, tap the clutch shaft and install the stop collar onto the snap ring.
Bearings
1. INSPECT REAR BEARING
Turn each bearing by hand while applying inward force. If resistance is felt or the bearing sticks, replace the bearing.
2. IF NECESSARY, REPLACE REAR BEARING
a. Using SST, remove the bearing.
SST 09286-46011
