Camry Sedan L4-2.0L (3S-FE) (1987)
Seat Belt Retractor Limit Switch: Testing and Inspection
Limit Switch Connector
1.
Disconnect limit switch connector.
Limit Switch Test
2.
Ensure there is no continuity between terminals #1 and #2 with front switch off (shoulder anchor at front end position).
3.
Ensure there is no continuity between terminals #3 and #4 with rear switch off (shoulder anchor at rear end position).
4.
Ensure continuity exists between terminals #1 and #2 with front switch on (shoulder anchor not at front end position).
5.
Ensure continuity between terminals #3 and #4 with rear switch on (shoulder anchor not at rear end position).
6.
If continuity is not as described, replace limit switch.