Camry Sedan L4-2.4L (2AZ-FE) (2003)
/Page-377001.png)
Timing Chain: Service and Repair
REPLACEMENT
1. REMOVE HOOD SUB-ASSY
2. REMOVE FRONT WHEEL RH
3. REMOVE ENGINE UNDER COVER LH
4. REMOVE ENGINE UNDER COVER RH
5. REMOVE FRONT FENDER APRON SEAL RH
6. DRAIN ENGINE OIL
a. Install a new gasket and the drain plug after draining engine oil.
Torque: 25 Nm (255 kgf-cm, 18 ft. lbs.)
7. REMOVE EXHAUST PIPE ASSY FRONT
8. REMOVE ENGINE MOVING CONTROL ROD W/BRACKET
a. Remove the 3 bolts and engine moving control rod w/ bracket.
9. REMOVE ENGINE MOUNTING STAY NO.2 RH
10. REMOVE ENGINE MOUNTING BRACKET NO.2 RH
11. REMOVE FAN AND GENERATOR V BELT
12. REMOVE ENGINE COVER SUB-ASSY NO.1
13. DISCONNECT ENGINE WIRE
14. REMOVE GENERATOR ASSY
15. REMOVE VANE PUMP ASSY
NOTICE: Do not disconnect the hose.
16. REMOVE IGNITION COIL ASSY
17. DISCONNECT VENTILATION HOSE
18. DISCONNECT VENTILATION HOSE NO.2
19. REMOVE CYLINDER HEAD COVER SUB-ASSY
a. Remove the bolt and disconnect the engine wire harness clamp.
b. Remove the 8 bolts and 2 nuts, and disconnect the cylinder head cover.
20. SET NO. 1 CYLINDER TO TDC/COMPRESSION
21. REMOVE CRANKSHAFT PULLEY
a. Remove the crankshaft pulley (TMC made).
