Camry Sedan L4-2.4L (2AZ-FE) (2003)
^
This torque value is effective in the case that SST is parallel to a torque wrench.
59. INSTALL STEERING RIGHT TURN PRESSURE TUBE
a. Coat 2 new O-rings with power steering fluid and install them to the right turn pressure tube.
b. Using SST, install the right turn pressure tube to the rack & pinion power steering gear assy.
SST 09023-38200
Torque: 11.5 Nm (117 kgf-cm, 8 ft. lbs.)
HINT:
^
Use a torque wrench with a fulcrum length of 345 mm (13.58 inch).
^
This torque value is effective in the case that SST is parallel to a torque wrench.
60. INSTALL POWER STEERING RACK HOUSING HEAT INSULATOR (1MZ-FE ENGINE TYPE)
a. Install power steering rack housing heat insulator.
HINT: Install nut when installing the return tube clamp.
61. INSTALL RACK & PINION POWER STEERING GEAR ASSY
a. Install the rack & pinion power steering gear assy with the 2 bolts and nuts.
Torque: 70 Nm (714 kgf-cm, 52 ft. lbs.)
b. Connect the tube clamp with the bolt.
Torque: 9.8 Nm (100 kgf-cm, 86 inch lbs.)
62. CONNECT PRESSURE FEED TUBE ASSY