Camry Sedan L4-2.4L (2AZ-FE) (2003)
C.
Place matchmarks on the steering intermediate shaft sub-assembly and steering gear assembly.
D.
Remove the bolt and disconnect the steering intermediate shaft sub-assembly.
2.
Remove the steering intermediate shaft sub-assembly.
A.
Place matchmarks on the steering sliding yoke sub-assembly and steering main shaft assembly.
B.
Remove the bolt and steering sliding yoke sub-assembly from the steering main shaft assembly.
3.
Slightly lift the spline shaft upward and expose the splines. Two teeth have been machined down to allow a needle to be inserted to apply the
lubricant. Once the missing spline has been located mark it.
The other machined spline is located 180 degrees from the original.
4.
Insert the needle into the shaft and then install the tube of lubricant to the needle.