Camry Sedan V6-180.5 2959cc 3.0L DOHC (3VZ-FE) (1992)
/Page-1131004.png)
Install two grommets
Install reservoir
-
Install the cap and strainer to the reservoir.
-
Push the reservoir onto the cylinder.
-
Install the set screw while pushing on the reservoir.
Torque: 1.7 Nm (15.2 in lb)
CAUTION: Because the master cylinder and reservoir tank union is a grommet type, the set screw is designed to not separate the reservoir
from the cylinder and will not tighten down the reservoir. Therefore, there is a clearance at point A. Do not insert washers or an equivalent
when tightening.
Conventional Brakes
