Camry Sedan V6-180.5 2959cc 3.0L DOHC (3VZ-FE) (1992)
/Page-1321002.png)
d. Remove the shims from the pressure plate.
2. Remove rotor.
a. Using a SST 07114-84020 remove the snap ring.
CAUTION: Do not spread the point of SST widely. Max width: 23.1 mm
b. Using a plastic hammer, tap the rotor off the shaft.
NOTE: Be careful not to damage the pulley when tapping on the rotor.
3. Remove stator.
a. Disconnect the stator lead wire from the compressor housing.
