Camry Sedan V6-180.5 2959cc 3.0L DOHC (3VZ-FE) (1992)
5. INSPECT CLUTCH RELEASE POINT
-
Pull the parking brake lever and install wheel stopper.
-
Start the engine and idle the engine.
-
Without depressing the clutch pedal, slowly shift the shift lever into reverse position until the gears contact.
-
Gradually depress the clutch pedal and measure the stroke distance from the point the gear noise stops (release point) up to the full stroke end
position.
Standard distance: 25 mm (0.98 in.) or more
(From pedal stroke end position to release point)
-
If the distance not as specified, perform the following operation.
-
Inspect pedal height.
-
Inspect push rod play and pedal freeplay.
-
Bleed the clutch line.
-
Inspect the clutch cover and disc.
6. CHECK CLUTCH START SYSTEM
-
Check that the engine does not start when the clutch pedal is released.
-
Check that the engine starts when the clutch pedal is fully depressed.
-
If necessary, adjust or replace the clutch start switch.
7. INSPECT CONTINUITY OF CLUTCH START SWITCH
-
Check that there is continuity between terminals when the switch is ON (pushed).
-
Check that there is no continuity between terminals when the switch is OFF (free).