Camry Sedan 2-Door V6-3.0L (1MZ-FE) (1994)
/Page-939001.png)
Fuel Rail: Service and Repair
Removal
PROCEDURE
1. Disconnect Negative (-) Terminal Cable From Battery
CAUTION: Work must be started after 90 seconds from the time the ignition switch Is turned to the LOCK position and the negative (-) terminal
cable is disconnected from the battery.
2. Drain Engine Coolant.
3. Disconnect Accelerator Cable.
4. Disconnect Throttle Cable.
5. Remove Air Cleaner Hose.
^
Disconnect the PCV hose.
^
Loosen the 2 hose clamps. and remove the air cleaner hose.
6. Remove V-bank Cover.
^
Using a 5 mm hexagon wrench, remove the 2 cap nuts and V-bank cover.
7. Remove Emission Control Valve Set.
Disconnect the following vacuum hoses:
