Camry Sedan 2-Door V6-3.0L (1MZ-FE) (1994)
/Page-940002.png)
^
Place the left hand delivery pipe and No.2 fuel pipe together with the 3 injectors in position on the intake manifold.
^
Connect the fuel return hose to the fuel pressure regulator.
^
Temporarily install the 2 bolts holding the left hand delivery pipe to the intake manifold.
^
Temporarily install the No.2 fuel pipe to the left hand delivery pipe with the union bolt and 2 new gaskets.
^
Check that the injectors rotate smoothly.
NOTE: If injectors do not rotate smoothly, the probable cause is incorrect installation of 0-rings. Replace the 0-rings.
^
Position the injector connector outward.
^
Tighten the 4 bolts holding the delivery pipes to the intake manifold.
Torque: 10 Nm (7 ft lb)
^
Tighten the bolt holding the No.1 fuel pipe to the intake manifold.
Torque: 19.5 Nm (14 ft lb)
^
Tighten the 2 union bolts holding the No.2 fuel pipe to the delivery pipes.
Torque: 32.5 Nm (24 ft lb)
