Camry Sedan 2-Door V6-3.0L (1MZ-FE) (1994)
/Page-1031003.png)
3. Remove emission control valve set.
4. Remove the Vacuum Switching Valve (VSV)
^
Disconnect the 2 vacuum hoses from the VSV.
^
Remove the screw and the VSV.
Installation
1. Reinstall the VSV with the screw.
2. Reinstall emission control valve set.
^
Connect the 2 vacuum sensing hoses to the VSV.
3. Reinstall V-bank cover. Using a 5 mm hexagon wrench. install the V-bank cover with the 2 cap nuts.
NOTE: When positioning the V-bank cover, push on the cover until a "click" is felt.
4. Reconnect Negative (-) Terminal Cable To Battery.
