Camry Sedan 2WD L4-2.0L (3S-FE) (1988)
Cold Start Injector: Service and Repair
Removal
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE TERMINAL OF BATTERY.
2. DISCONNECT COLD START INJECTOR CONNECTOR.
3. REMOVE COLD START INJECTOR PIPE.
a. Put a suitable container or shop towel under the injector pipe.
b. Remove the two union bolts, four gaskets and injector pipe.
NOTE: Slowly loosen the union bolts.
4. REMOVE COLD START INJECTOR.
Remove the two bolts, injector and gasket.