Camry Sedan 2WD L4-2.0L (3S-FE) (1988)
/Page-900012.png)
14. INSTALL DUST COVER
15. INSTALL CLAW WASHERS AND RACK ENDS
a. Install a new claw washer.
b. Using SST, install and torque the rack ends. SST 09612-10093 (09628-10020) 09612-24014(09617-24011) Torque: 730 kg-cm (53 ft-lb, 72
N.m)
HINT:
-
Use a torque wrench with a fulcrum length of 340 mm (13.39 in.).
c. Using a brass bar and hammer, stake the claw washer.
16. INSTALL RACK BOOTS, CLAMPS AND CLIPS
a. Insure that the tube hole is not clogged with grease.
HINT:
-
If the tube hole is clogged, the pressure inside the boot will change after it is assembled and the steering wheel turned.
b. Install the boots.
HINT:
-
be careful not to damage or twist the boots.
c. Install the clamps.
d. Install the clips with the ends facing outward.
