Camry Sedan 2WD V6-2507cc 2.5L DOHC (2VZ-FE) (1990)
19. REMOVE JUNCTION BLOCK NO.3
(a) Remove the speaker.
(b) Remove the two screws and junction block No.3.
20. REMOVE SAFETY PAD
(a) Push on the pawls of speedometer cable, bracket and pull it from the safety pad.
(b) Remove the four bolts, two screws, two nuts and the safety pad.
HINT: The safety pad has a boss on the reverse side for clamping onto the clip on the body side. Therefore, when removing, pull, upward at an
angle.
(c) Remove the clips and disconnect the wire harness from the safety pad.
21. REMOVE NO.1 HEATER REGISTER DUCT
Pry out the clip and remove the duct.
22. REMOVE NO.3 HEATER REGISTER DUCT
Remove the three screws and duct.
23. REMOVE DEFROSTER NOZZLE
Remove the five screws and nozzle.
24. REMOVE NO.1 INSTRUMENT PANEL REGISTER
Remove the two screws and register.
25. REMOVE NO.3 INSTRUMENT PANEL REGISTER
Remove the three screws and register.