Camry Sedan 2WD V6-2507cc 2.5L DOHC (2VZ-FE) (1990)
Alignment: Service and Repair
Rear
Note: Camber angle is preset and not adjustable. If camber angle is not to specification, inspect and/or replace suspension components as required.
Adjust Toe-in
1. Measure the distance between each wheel disc and corner of the cam bracket and confirm that both are the same.
Left-right error: Less than 3 mm (0.12 in.)
If the left-right error is greater than 3 mm (0.12 in.) adjust following the procedures below.
If the toe-in is out of the standard toward toe-out side, lengthen the shorter arm by the cam.
If the toe-in is out of the standard toward toe-in side, shorten the longer arm by the cam.