Camry Sedan 2WD V6-2507cc 2.5L DOHC (2VZ-FE) (1990)
Knock Sensor: Service and Repair
Removal
PROCEDURE
1. Remove the Intake Chamber assembly.
2. Disconnect Injector connectors.
^
Disconnect the heater hose from the Intake Manifold.
^
Remove the 9 bolts. 2 nuts, 2 plate washers and Intake Manifold assembly.
3. Remove right hand engine mounting stay and water outlet.
^
Disconnect the following hoses and connectors:
-
Radiator inlet hose. (1)
-
Engine coolant reservoir hose. (2)
-
Engine Coolant Temperature Sensor connector. (3)
-
Engine Coolant Temperature Switch connector. (4)
-
Ground strap connector. (5)
^
Remove the 3 bolts and right hand mounting stay.
^
Remove the wire band.