Camry Sedan 2WD V6-2507cc 2.5L DOHC (2VZ-FE) (1990)
Control Arm: Service and Repair
Rear
1.
Raise and support rear of vehicle.
2.
Remove bolt and nut securing suspension arm No. 2 to axle carrier.
3.
Scribe alignment marks on suspension arm No. 2 alignment cam plate to aid during installation, then remove bolt securing suspension arm No. 2 to
body and remove arm. When removing bolt securing suspension arm to body, turn the bolt only. Do not turn the cam.
4.
Remove bolt and nut securing suspension arm No. 1 to axle carrier.
5.
Remove bolt and nut securing suspension arm No. 1 to body, then remove arm.
6.
Replace bushings with installer tool No. 09726-32010.
7.
Reverse procedure to install. Torque all bolts to specification with vehicle weight on suspension.