Camry Sedan 2WD V6-2507cc 2.5L DOHC (2VZ-FE) (1990)
4. CHECK OIL PUMP BODY BUSHING
Using a dial indicator, measure the inside diameter of the oil pump body bushing.
Maximum inside diameter: 38.18 mm (1.5031 in.)
If the inside diameter is greater than the maximum, replace the oil pump body subassembly.
5. CHECK STATOR SHAFT BUSHINGS
Using a dial indicator, measure the inside diameter of the stator shaft bushings.
Maximum inside diameter:
Front side 21.57 mm (0.8492 in.)
Rear side 27.07 mm (1.0657 in.)
If the inside diameter is greater than the maximum, replace the stator shaft.
ASSEMBLY OF OIL PUMP
1. INSTALL FRONT OIL SEAL
Using SST and a hammer, install a new oil seal. The seal end should be flush with the outer edge of the pump body.
SST 09350-32014 (09351-32140)