Camry Sedan 2WD V6-2507cc 2.5L DOHC (2VZ-FE) (1990)
/Page-891005.png)
2. INSTALL DRIVEN GEAR AND DRIVE GEAR
Make sure the top of the gears are facing upward.
3. INSTALL STATOR SHAFT ONTO PUMP BODY
Align the stator shaft with each bolt hole.
4. TIGHTEN ELEVEN BOLTS
Torque: 100 kg-cm (7 ft-lb, 10 N.m)
5. INSTALL THRUST WASHER
a. Coat the thrust washer with petroleum jelly.
b. Align the tab of the washer with the hollow of the pump body.
6. INSTALL TWO OIL SEAL RINGS ON OIL PUMP
Spread the rings apart and install them into the groove.
