Camry Sedan 2WD V6-2507cc 2.5L DOHC (2VZ-FE) (1990)
NOTICE: The hub bearing could be damaged if it is subjected to the vehicle weight. such as when moving the vehicle with the drive shaft
removed. Therefore, if it is absolutely necessary to place the vehicle weight on the hub bearing, first support it with SST.
SST 09608-16041 (09608-02020, 09608-02040)
REMOVAL OF DRIVE SHAFT
1. REMOVE COTTER PIN. LOCK NUT CAP AND LOCK NUT
(a) Remove the cotter pin and lock nut cap.
(b) Loosen the bearing lock nut while depressing the brake pedal.
2. REMOVE ENGINE UNDER COVERS
3. DISCONNECT TIE ROD END
(a) Remove the cotter pin and nut from the tie rod end.
(b) Using SST, disconnect the tie rod end from the steering knuckle.
SST 09628-62011