Camry Sedan 4-Door L4-132 2164cc 2.2L DOHC (5S-FE) (1995)
2. INSPECT 3RD AND 4TH GEAR RADIAL CLEARANCE
Using dial indicator, measure the radial clearance between the gear and shaft.
Standard clearance: 0.009 - 0.053 mm (0.0004 - 0.0021 in.)
Maximum clearance: 0.070 mm (0.0028 in.)
If the clearance exceeds the maximum, replace the gear, needle roller bearing or shaft.
3. REMOVE SNAP RING
Using 2 screwdrivers and a hammer, tap out the snap ring.
4. REMOVE REAR BEARING, 4TH GEAR, NEEDLE ROLLER BEARINGS, SPACER AND SYNCHRONIZER RING FROM INPUT SHAFT
a. Using SST and a press, remove the 4th gear and rear bearing.
SST 09950-00020
b. Remove the needle roller bearings, spacer and synchronizer ring.
5. REMOVE SNAP RING
Using a snap ring expander, remove the snap ring.
6. REMOVE NO.2 HUB SLEEVE ASSEMBLY, 3RD GEAR SYNCHRONIZER RING AND NEEDLE ROLLER BEARINGS
Using SST and a press, remove the No.2 hub sleeve, 3rd gear, synchronizer ring and needle roller bearings.
SST 09950-00020
NOTE: Be careful not to confuse the synchronizer ring for 3rd gear and synchronizer ring for 4th gear.