Camry Sedan 4-Door L4-132 2164cc 2.2L DOHC (5S-FE) (1995)
2. INSPECT NO.2 SHIFT FORK AND HUB SLEEVE CLEARANCE
Using a feeler gauge, measure the clearance between the hub sleeve and shift fork.
Maximum clearance: 1.0 mm (0.039 in.)
If the clearance exceeds the maximum, replace shift fork or hub sleeve.
3. INSPECT INPUT SHAFT
a. Check the input shaft for wear or damage.
b. Using a micrometer, measure the outer diameter of the input shaft journal surface.
Minimum outer diameter:
Part A: 26.970 mm (1.0618 in.)
Part B: 32.470 mm (1.2783 in.)
Part C: 33.090 mm (1.3028 in.)
Part D: 29.970 mm (1.1799 in.)
If the outer diameter is less than the minimum, replace the input shaft.
c. Using a dial indicator, check the shaft runout.
Maximum runout: 0.05 mm (0.0020 in.)
If the outer diameter exceeds the maximum, replace the input shaft.
INPUT SHAFT ASSEMBLY
HINT: Coat all of the sliding and rotating surfaces with gear oil before assembly.
1. INSTALL NO.2 CLUTCH HUB INTO HUB SLEEVE