Camry Sedan 4-Door V6-3.0L (1MZ-FE) (1994)
/Page-1506001.png)
Compressor Speed Sensor: Testing and Inspection
ON-VEHICLE INSPECTION
1. Disconnect negative (-) cable from battery.
CAUTION: Work must be started after 90 seconds from the time the ignition switch is turned "LOCK" position and the negative (-) terminal
cable is disconnected from the battery.
2. Disconnect connector of revolution detecting sensor
3. Inspect revolution detecting sensor. Check the resistance between terminals 1 and 2 of the sensor.
Specified resistance: 65 - 125 Ohms at 20 °C (68°F)
If the resistance value is not as specified, replace the revolution detecting sensor.
