Camry Sedan 4-Door V6-3.0L (1MZ-FE) (1994)
b. Disconnect the following connectors:
(1) VSV connector for ACIS
(2) VSV connector for EGR
(3) VSV connector for fuel pressure control
c. Remove the 2 nuts and emission control valve set.
4. Remove VSV.
a. Disconnect the 2 vacuum hoses from the VSV.
b. Remove the screw and VSV.
PROCEDURE
Removal
1. Disconnect negative (-) terminal cable from battery.
CAUTION: Work must be started after 90 seconds from the time the ignition switch is turned to the LOCK position and the negative (-) terminal
cable is disconnected from the battery.
2. Remove V-bank cover. Using a 5 mm hexagon wrench, remove the 2 cap nuts and V-bank cover.