Camry Sedan 4-Door V6-3.0L (1MZ-FE) (1994)
/Page-1373005.png)
a)
Reconnect the airbag connector.
b)
Reinstall the steering wheel pad after confirming that the circumference grove of the Torx(R) screws are caught in the screw case.
c)
Using a T30 Torx(R) socket, tighten the (3) screws.
Torque: 8.8 N.m (90 kgf.cm, 78 in.lbf)
d)
Reinstall the Torx(R) bolt covers on the steering wheel.
NOTES:
^
If the airbag has been dropped or there are cracks, dents, or other defects to the case or connector, replace the airbag.
^
When installing the airbag, take care not to pinch the Wiring between other parts.
6.
Reconnect the negative (-) battery terminal.
7.
Check SRS warning light.
a)
Turn ignition to "ON" or "ACC" and check that the SRS warning light illuminates.
b)
Check that the SRS warning light goes out after approximately 6 seconds.
8.
Reprogram the radio presets and reset the clock.
SSC Completion Label Installation
a)
After completing repair and before returning the vehicle to the owner, a SSC completion label, that is enclosed in the owner's notification
must be affixed to the left front door hinge post, near the check strap.
b)
The label is to be filled out as follows:
