Camry Sedan 4-Door V6-3.0L (1MZ-FE) (1994)
7. CONNECT STABILIZER BAR LINK TO LOWER ARM
Torque: 39 N.m (400 kgf.cm, 29 ft.lbf)
8. CONNECT TIE ROD END TO STEERING KNUCKLE
-
Connect the tie rod end to the steering knuckle and torque the nut.
Torque: 49 N.m (500 kgf.cm, 36 ft.lbf)
-
Install a new cotter pin.
HINT: If the cotter pin hole does not line up, correct by tightening the nut by the smallest amount possible.
9. INSTALL BEARING LOCK NUT, LOCK NUT CAP AND NEW COTTER PIN
-
Install and torque the bearing lock nut.
Torque: 294 N.m (3,000 kgf.cm, 217 ft.lbf) See TSB DL001-98, 3-6-98.
-
Install the lock nut cap and secure it with a new cotter pin.
10. FILL TRANSAXLE WITH GEAR OIL
11. INSTALL FRONT FENDER APRON SEAL